[I2C] START
[I2C] Writing 1 bytes
[I2C] Write address 0x32
[Data Request] Protocol request failed
[Data Request] Error: Protocol request failed
[Send Packet] Length 80
[Send Packet] COBS encoded buffer length: 82
[BPIO] COBS delimiter found, stopping read
[BPIO] Flatbuffer data read complete, total length: 66
[BPIO] Packet Type: 3
[Data Request] Start main condition: true
[Data Request] Start alternate condition: false
[Data Request] Bytes to write: 1
[Data Request] Bytes to read: 1
[Data Request] Stop main condition: true
[Data Request] Stop alternate condition: false
[I2C] Performing transaction
[I2C] START
[I2C] Read address 0x33
[Data Request] Protocol request failed
[Data Request] Error: Protocol request failed
[Send Packet] Length 84
[Send Packet] COBS encoded buffer length: 86
[BPIO] COBS delimiter found, stopping read
[BPIO] Flatbuffer data read complete, total length: 66
[BPIO] Packet Type: 3
[Data Request] Start main condition: true
[Data Request] Start alternate condition: false
[Data Request] Bytes to write: 1
[Data Request] Bytes to read: 0
[Data Request] Stop main condition: true
[Data Request] Stop alternate condition: false
[I2C] Performing transaction
[I2C] START

I2C> scan
I2C address search:
0x19 (0x32 W) (0x33 R)
0x1C (0x38 W) (0x39 R)
0x48 (0x90 W) (0x91 R)

Found 6 addresses, 3 W/R pairs.

I2C> i

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that may cause undesired operation.

Bus Pirate 6
https://BusPirate.com/
Firmware main branch @ unknown (Dec 20 2025 07:56:01)
RP2350B with 512KB RAM, 128Mbit FLASH
S/N: 442CD5B5206B7C03
Storage:   0.10GB (FAT16 File System)

Configuration file: Loaded
Active binmode: BPIO2 flatbuffer interface
Available modes: HiZ 1WIRE UART HDUART I2C SPI 2WIRE 3WIRE DIO LED INFRARED JTAG
Active mode: I2C
 I2C speed: 100 kHz
 Clock stretching: OFF 

Display format: Auto
Data format: 8 bits, MSB bitorder
Pull-up resistors: ON
Power supply: ON (3.3V/3.29V)
Current limit: OK (3.7mA/0.0mA)
Frequency generators: OFF