It’s been a busy holiday weekend:
REV 10 passed FCC testing. All the parts went to the assembler today. PCBs won’t be done until tomorrow night, but they will be shipped to the assembler directly.
The injection molding should be re-done any minute now, but I don’t trust them any further than I can throw them 
I’ve almost got the hardware documentation updated, I’ll push that before the end of the week.
KF141 boards have been a bit lost in the shuffle, but they should go to assembly before the end of the week as well.
Hopefully I can go back to firmware next week. I need to start with a clean split of rev8/rev10 in the code, then I’m going to continue with binary mode.